Tools

Features:
• Powered by a 9-volt battery.
• Lightweight, small & completely portable.
• LED panel on front of tester indicates Pass or Fail.
• If Fail, panel saves valuable diagnostic time by indicating whether due to Short, Open Conductor or Open Shield.

Used for Demonstration 
MRF: RF Industries
SKU: RFA-4018-20-D

For LMR600
No dies included - handle only
Piston Style Crimp Tool
MFR: RF Industries
SKU: RFA-4009-20

Crimp Frame without Die Sets
MFR: Amphenol
SKU: 47-10000

The RFA-4005-20 crimp handle is precision manufactured of high-carbon, heat-treated, stamped steel and designed for smooth and rapid die closure. A simple pressure adjustment resets the scissors ratchet mechanism to compensate for different crimp dies and crimp forces. When the correct die is used, the full cycle ratchet will not release until a clean and tight crimp is achieved. Should a mismatch occur, the disengagement lever quickly releases the ratchet mechanism.

MFR: RF Industries
SKU: RFA-4005-20

See Die Sets

100% machined Aluminium
T-Insertion Tool 2-1/2" Overall Length
Used to install COMP-NM-400.
Cable Group: I
Cable Types: LMR400, CNT400
MFR: RF Industries
SKU: IT50NM 

Crimp Tool for LMR600 Crimp Connectors
MFR: Times Microwave Systems
SKU: CT-600

LMR^® is a registered trademark of Times Microwave Systems.

Crimp Tool for LMR^®100, 195, 200, 240 Connectors

MFR: Times Microwave
SKU: CT240/200/195/100

LMR^® is a registered trademark of Times Microwave Systems.

Installation Tool Kit for both LMR^®400 & 600 connectors

Kit includes the following:

CT-U Crimp Handle with 2 dies (0.429 - Y1719 & 0.610 - Y1720), CCT-02 Cutting Tool, CST-400 Stripping Tool for LMR^®400 Connectors, CST-600 Stripping Tool for LMR^®600 Connectors, and tool pouch.

Special Order, Delivery is 3-4 weeks

MFR: Times Microwave Systems
SKU: TK-01

LMR^® is a registered trademark of Times Microwave Systems.

HT-301 Deluxe Ratchet Crimping Handle/Die for Insulated Connectors 10-22 ga (63-1007) 8.7"

SKU: HT-301